MV250 Boxed Multivent – VENT AXIA 181510
The Multivent continuous mechanical extract ventilation range is designed for the simultaneous ventilation of separate areas in the home or as a multi-point extractor system for a wide range of commercial applications.
In the home, the system is usually located in the loft or airing cupboard with ducts taken to the bathroom, kitchen and utility room to remove water vapour at source and from WC’s to remove odours. Designed to provide 0.7 of an air change based on the volume of the building, the Multivent system provides adequate ventilation, even in a ‘tight’ dwelling. Pollutant concentrations and humidity can be controlled.
The Multivent H versions are now available with 2 control options. An integral humidity sensor that will detect any rise in humidity within the system and will boost between any 2 of the 3 speeds. A new Wire-less Controller is available for use with the Multivent H with 3-speed options offering total control of the systems.
Multivent MV250 and MV350 are guaranteed for 2 years with an extended motor guarantee to 5 years offered on the MVDC LoWatt Energy Saving model.
- Fan: The impeller should be a centrifugal backward curved type, dynamically balanced mounted directly onto the motor.
- Motor: The AC version should be a capacitor run external rotor motor capable of 3 fixed speeds. 240V 50Hz A/C with ball race bearings, greased for life. It shall operate up to an ambient temperature of 40°C and be fitted with a one-shot thermal overload protective device.
- Ducting spigots: Ducting spigots: The unit should have 4-N° 100/125mm Ø extract points and 1x125mm outlet to atmosphere. (Can be converted to flat ducting).
- Filter: not fitted.
- Condensation: Two 15mm condensate drain outlets on the side of the unit at both the top and the bottom for different mounting positions.
- Construction: The unit should be moulded in ABS plastic.
- Sound Levels: Refer to the above table for maximum performance.
- Mains electrical supply: 230VAC 50Hz.
- Complies to the following approvals/directives: LVD, EMC, BEAB and CE.
- £25 to run per annum depending on the energy provider
FID | |————- dB(A) @ 3m ————-| | |||
Performance m³/h | Casing Breakout | Duct Inlet 100mm Ø | Duct Inlet 125mm Ø | |
MV250
low medium high |
161 305 443 |
22.4 31.0 35.4 |
27.9 42.9 48.6 |
27.8 43.2 48.0 |
MV250H
low medium high |
175 344 443 |
22.4 31.0 35.4 |
27.9 42.9 48.6 |
27.8 43.2 48.0 |
Reviews
There are no reviews yet.