Rytons Aircore – Push-Pull Louvre Panel Passive Vent Set

• Retro-fitted core ventilator for background room ventilation.
• The unrestricted tube allows a high equivalent area over 7000mm².
• New and uniquely designed internal LookRyt® panel disperses air evenly into the room and may be painted or wallpapered to match décor.
• LookRyt® panel manually adjusted with an easy push/pull controllable action giving the occupier full control over the amount of ventilation let into the room.
• External water baffle prevents the transfer of water across the cavity.
• Interlocking components aid correct positioning, alignment and easy installation.
• External grille U.V. stabilised to slow down the effects of sunlight.
• LookRyt® panel easily secured using fixing screws provided.
• Verifiable equivalent area confirmed by the BRE.

Equivalent Area

7500mm² (75cm²) per set.

Size

External Grille: 166mm L x 160mm H.
Tube: 127mm (5″) Dia. x 358mm L.
LookRyt® Panel: 172mm L x 172mm H.

Choice of external grille:

Terracotta (RYTAC10HPTC)
Buff/Sand (RYTAC10HPBS)
White (RYTAC10HPWH)

Composition

External Grille: U.V. stabilised high impact polystyrene.
Tube: High impact polystyrene.  The tube contains recycled plastic.
LookRyt® Panel: High impact styrene.

Softening / Melting Points: Tube: Softening point 70ºC, melting point 120ºC.

Installation

Warning: DO NOT attach the internal LookRyt® face panel until the internal LookRyt® backplate is fixed to the wall using the screws provided.  Screws: The four screws provided are for fixing the internal LookRyt® backplate to the internal wall.  Any suitable fixings can be used for the external grille, dependent on the external surface.

To comply with Building Regulations Part F the ventilator should be sited not less than 1.7m above floor level.
Drill a hole using a 127mm diameter core drill.
Cut the tube to length if necessary then insert the tube into the hole.
Align and push-fit the external louvre and backplate (screw into position for extra security).  Tip: Save installation time by securing the external louvre grille to the backplate with a mastic sealant.
DO NOT attach the internal LookRyt® face panel until the internal LookRyt® backplate is fixed to the wall using the screws provided.
Align and screw the internal LookRyt® backplate to the wall using the screws provided.
ONLY when the internal LookRyt® backplate is screwed in place can you push-fit the internal LookRyt® face panel.
The grille may then be opened and closed using a manual push/pull action.
The internal LookRyt® face panel can be painted or wallpapered to match the room décor.
Consideration should be given to using Rytons AirCore® Cowl (ABC8) externally in exposed areas.